Fall fertilization of brome pastures

Share Tweet Email

Brome requires annual fertilization for optimum production. Fall is a good time to plan on fertilizing cool-season perennial grasses such as smooth brome (Figure 1). Particular attention must be paid to nitrogen, phosphorus, potassium, and pH.

Balanced fertility is essential. For example, adding nitrogen will not produce optimum yields if phosphorus is low. Soils low in phosphate limit plant and root growth. Fertilizer should be applied by broadcasting in the fall or before spring growth begins.
 

A close-up of grassDescription automatically generated
A field of grass with trees in the backgroundDescription automatically generated

Figure 1. Fall growth of established smooth brome field prior to fertilizer application. Photos by John Holman, K-State Research and Extension.

 

Nitrogen Source. Nitrogen management is critical for optimum smooth brome production. Several nitrogen sources are available—liquid nitrogen solutions, urea, ammonium nitrate, and anhydrous ammonia. Anhydrous ammonia is not extensively used on permanent pastures because application is difficult. Nitrogen source research generally has shown little difference among sources under most conditions. When urea fertilizers—including liquid nitrogen—are applied to moist soils covered with grass residue, an enzyme called urease can break down the urea to ammonia, which is lost to the air. This can occur fairly rapidly when moist conditions are followed by warm temperatures and rapid drying occurs without rain to move the urea into the soil. If urea is applied from November through February, volatilization loss should be minimal.

Application Timing. When brome is grazed in the fall, the yearly nitrogen application should be split. If adequate soil moisture is available for good growth in late August and early September, apply all phosphorus and potassium indicated by a soil test plus 30-40 pounds of nitrogen per acre. Before the soil freezes in November or December, apply the remainder of the nitrogen recommended for haying or grazing. Split or late fall applications generally initiate earlier green-up in the spring.

If soil moisture is limited, apply all nitrogen, phosphorus, and potassium before the soil freezes in November or December. Do not apply fertilizer to frozen soil to minimize loss.

Spring applications as soon as the soil thaws are acceptable for spring-only grazing. Timely application is often delayed because of wet soils. An application needs to be applied in the fall or early spring to allow sufficient time for fertilizer incorporation to benefit forage production (Figure 2).


A graph of different types of applicationDescription automatically generated with medium confidence

Figure 2. Timing of N application on smooth brome yield. Source: KSRE publication C402 Smooth Brome Production and Utilization.


Fertilizer Rates (N, P, and K). Fertilizer rate recommendations for N, P, and K for established stands of smooth bromegrass are shown in Tables 1, 2, and 3, respectively. When brome is to be utilized for hay production, excessive nitrogen may cause lodging and reduce the amount of harvestable hay. In Table 1, the lower values in the rate range are for hay production. Nitrogen rate should be selected based on factors such as fertilizer cost, hay price, and/or grazing pressure.

 

Table 1. Nitrogen recommendations for smooth bromegrass.

Type

Area of State

lb/a N1

New Seeding

Entire

30-40

Established Stands:

   

Non-irrigated

Eastern

80-120

Non-irrigated

Central

40-80

Irrigated

Entire

125-200

1In established stands, the lower recommendations are for hay
management only. The higher rates are for grazing or grazing and hay management.

 

Table 2. Phosphorus recommendations for smooth bromegrass.

 

Soil Test Level (ppm P)

 

Very Low

Low

Medium

High

Very High

Type

(0-5)

(6-12)

(13-25)

(26-50)

(51 or more)

 

lb/a P2O5

New Seeding

60-80

40-60

20-40

None

None

Established Stands:

         

Non-irrigated

30-50

20-40

0-30

None

None

Irrigated

50-60

40-50

20-40

10-20

None

 

Table 3. Potassium recommendations for smooth bromegrass.

 

Soil Test Level (ppm K)

 

Very Low

Low

Medium

High

Very High

Type

(0-40)

(41-80)

(81-120)

(121-160)

(161 or more)

 

lb/a K2O

New Seeding

80-100

60-80

30-60

0-30

None

Established Stands:

         

Non-irrigated

30-50

20-40

0-30

None

None

Irrigated

50-60

40-50

20-40

0-20

None

 

 

John Holman, Cropping Systems Agronomist – Garden City
jholman@ksu.edu

Dorivar Ruiz Diaz, Soil Fertility Specialist
ruizdiaz@ksu.edu


Tags:  pastures fall fertilizer bromegrass fertilization smooth brome 

Search
Events
Subscribe