Pre-emergence herbicides for corn

Share Tweet Email

 

Pre-emergence herbicides kill weed seeds/seedlings as they germinate or emerge. Applications of pre-emergence herbicides at or before corn planting are important to minimize yield losses to early-emerging weeds. These herbicides often control weeds for several weeks, which can greatly improve the effectiveness of a post-emergence herbicide application and give more flexibility for post application timing. Pre-emergence herbicides are also an important component of sequential herbicide applications later in the growing season. In general, preventing the emergence of weeds, especially herbicide resistant weeds, is preferable to controlling them after they emerge (Figure 1).


Figure 1. The corn plot in the foreground received no pre-emergence herbicide. The plots adjacent to the untreated check received an application of pre-emergence herbicide. The photo was taken just prior to the prescribed post-emergence treatment in May 2018 at the Kansas River Valley Experiment Field in Rossville. Photo by Stu Duncan, K-State Research and Extension.


Much of the resistance to glyphosate has developed from over-reliance on post-emergence herbicide applications, thus it is essential to include one or more of the pre-emergence residual herbicides available for corn. However, it is also important to remember to change pre-plant and pre-emergence herbicide programs from time to time to prevent selection of tolerant or resistant weeds.

The specific herbicide you use is important, but it is usually less important than making the decision to use a pre-emergence herbicide. But, it is important to know the strengths and weaknesses of each product in terms of the spectrum of weeds controlled. A table summarizing weed species response to various corn herbicides can be found on pages 24-26 of 2020 Chemical Weed Control for Field Crops, Pastures, Rangeland, and Noncropland (SRP 1155) at: https://www.bookstore.ksre.ksu.edu/pubs/SRP1155.pdf

 

Categories of soil-applied residual herbicides for corn

Triazines (Group 5). Atrazine is the most widely used triazine in corn. It is a common component of many preplant and pre-emergence herbicide premixes for corn. It controls a wide variety of broadleaf weeds, including pigweeds, ragweeds, morningglories, and mustards, as well as some grass species. However, atrazine resistance has been reported for many weed species. Atrazine use rates are influenced by soil type, soil pH, and organic matter, and use is prohibited in instances where water contamination is likely. Unless your situation prohibits atrazine use, it is recommended to include atrazine when you apply HPPD-inhibitor and acetamide herbicides.

Acetamides and pyrazole (Group 15). The main acetamide (15) products used in corn include acetochlor, S-metolachlor, metolachlor, dimethamid-P, and many premix products containing one of these active ingredients. Pyroxasulfone is a pyrazole herbicide, but has the same site of action as the acetamides. In general, these products are very effective in controlling most annual grasses (except shattercane) and small-seeded broadleaf weeds such as pigweeds. They are much less effective in controlling small-seeded kochia or large-seeded broadleaf weeds such as cocklebur, devilsclaw, morningglory, sunflower, and velvetleaf. An exception are those products containing pyroxasulfone, such as Zidua, Anthem, and Anthem ATZ, Fierce and Fierce MTZ. Engenia Pro and Purpetuo are two other pyroxasulfone-containing products that are awaiting approval Though resistance to Group 15 herbicides have been reported in corn/soybean rotations in Illinois, there have been no cases of weed populations in Kansas developing resistance to the group 15 herbicides to date.

The acetamide and pyrazole products are most effective when applied with atrazine. Several such premixes are available and should be used instead of acetamides or pyrazole alone, unless atrazine is not allowed. These premixes generally fit into two groups: products with a reduced atrazine rate (1 lb or less/acre) and products with a full atrazine rate (1 to 2 lb/acre). Soil characteristics determine whether the reduced- or full-rate atrazine product is used. In past years, often because of cost, reduced rates of these products were applied to help manage heavy summer annual grass pressure, then followed up with a good post-emergence herbicide program. With the increased occurrence of glyphosate- and other herbicide-resistant weeds, it is essential to use the full rates of these products in conjunction with a POST program.

HPPD-inhibitors (Group 27). Examples of HPPD-inhibitors are isoxaflutole (e.g. Balance Flexx) and mesotrione (e.g. Callisto and many generics). These products should be applied with atrazine, which is often included in premixes with Group 27 herbicides (e.g. Acuron, Callisto Xtra, Lexar EZ, Lumax EZ). HPPD-inhibitors provide excellent for control of kochia, pigweeds, velvetleaf, and many other broadleaf weeds, as well as grasses. Corvus (thiencarbazone + isoxaflutole) will control shattercane and common sunflower better than Balance Flexx, provided the sunflower is not ALS-resistant. Prequel has a low rate of Balance mixed with Resolve and will not provide the same level of residual weed control as Acuron, Resicore, Lexar EZ, Lumax EZ, Balance Flexx, or Corvus used at full rates. Keep in mind, products containing Balance should not be applied to coarse-textured soils when the water table is less than 25 feet below the soil surface. Balance Flexx does not provide adequate control of sunflower.

PPO-inhibitors (Group 14). Examples of PPO-inhibitors include flumioxazin (e.g. Valor) and saflufenacil (Sharpen (14). Herbicides containing flumiozaxin must be applied 7 to 30 days before corn planting. These herbicides provide excellent control of pigweeds; however, they are marginal on kochia. Fierce (flumioxazin + pyroxasulfone) will provide improved control of velvetleaf and kochia compared to Valor. The addition of atrazine will enhance kochia, pigweed, velvetleaf, and morningglory control, provided the populations are not triazine-resistant. Sharpen and Verdict (saflufenacil + dimethenamid-P) have excellent activity on pigweeds, kochia, and large-seeded broadleaf weeds. However, the length of residual activity can be shorter than other pre-emergence products when all are compared at full rates. Approximately 7 to 10 days of residual can be expected per 1 oz. of Sharpen and 5 oz. of Verdict.

ALS-inhibitors (Group 2). One example of a pre-emergence ALS-inhibitor used in corn is flumetsulam (Python), which only has broadleaf activity and provides good control of large-seeded broadleaf weeds such as cocklebur, sunflower, and velvetleaf, or the small-seeded common lambsquarters. Flumetsulam is also a component of Hornet, Stanza, SureStart II, and TripleFlex II. These products are especially effective for control of sunflower, along with cocklebur and velvetleaf, but less effective for morningglory control.

Rimsulfuron is another ALS-inhibiting herbicide that is a component of Basis Blend, Instigate, Prequel, Realm Q and Steadfast Q. Products with rimsulfuron will provide short residual control of grass and broadleaf weeds and should be used as a setup herbicide with a good postemergence weed control program. If ALS-resistant broadleaf weeds are present, these ALS-containing herbicides often will be less effective.

 

Sarah Lancaster, Extension Weed Science Specialist
slancaster@ksu.edu


Tags:  corn weed control pre-plant herbicide