2020 K-State wheat variety fall forage yield comparison

Share Tweet Email


Fall forage yield is an important aspect of dual-purpose wheat production. In this system, wheat is typically sown earlier than for grain-only production, at higher seeding rates, and with additional nitrogen fertilizer to maximize forage production.

The weather experienced during the fall is crucial in determining the average level of forage yield, with warm and moist weather typically resulting in greater forage yield than cool and dry weather conditions. Management practices that maximize forage yield include early sowing, higher seeding rates, placement of in-furrow phosphorus fertilizer with the seed, and fall nitrogen fertilization.

While the weather is typically the largest factor in determining fall forage production, followed by management, there are also differences among wheat varieties in forage production potential. Thus, every year the K-State Wheat Production Group compares the forage yield of several commonly grown wheat varieties and upcoming lines. This test is usually performed in the South Central Experimental Field near Hutchinson, Kansas (Figure 1), and the forage sampling occurs sometime during December (Table 1).
 

Figure 1. Dual-purpose wheat trial near Hutchinson, KS. The trial was sown on September 18, 2019, with 50 lbs DAP/acre applied in furrow, and 90 lbs N/acre broadcast incorporated prior to sowing. Photo by Romulo Lollato, K-State Research and Extension.

Table 1. Fall forage yield of wheat varieties sown under dual-purpose system near Hutchinson, KS. Forage biomass was collected on 20 December 2019. Data is shown in pounds of dry matter per acre (lbs DM/ac). Tukey’s honest least significant difference (HSD) is shown, with highest yielding group highlighted in bold. Varieties are ordered from highest to lowest forage yield.

Variety

Forage dry matter (12/20/19)

 

------- lbs/ac -------

Gallagher

1888

WB4303

1765

Rock Star

1618

WB4269

1523

Paradise

1385

Smith's Gold

1357

WB4792

1294

AM Cartwright

1163

WB4699

1146

Green Hammer

1144

Doublestop CL Plus

1095

TAM205

1015

Zenda

983

09BC308-14-16

906

Whistler

884

Bentley

884

Guardian

849

KS Western Star

809

KS Dallas

805

Bob Dole

751

SY Wolverine

745

WB4595

725

Long Branch

683

Showdown

634

LCS Valiant

540

KS Silverado

538

AM Eastwood

475

SY Achieve CL2

438

HSD

595

 

There was a significant difference in fall forage yield among the 28 wheat varieties tested in the 2019-2020 experiment (Table 1). Forage yield ranged from 438 to 1,888 pounds of dry matter per acre, with Gallagher, WB4303, Rockstar, WB4269, Paradise, Smith’s Gold, and WB4792 yielding similarly in the top forage group. Likewise, all varieties listed at TAM 205 and below had similar forage yield and did not differ statistically.

Impact of weather conditions on 2019 fall forage production

While it is common for a large range in forage yields to exist among wheat varieties (for example, in 2018-19 our forage measurements ranged from 1,327 to 2,700 lbs/acre), the large range in forage values experienced in the 2019-20 partially reflect the dry conditions experienced during the fall. Plots were planted on extremely dry soils on September 18, and it was not until the October 1-5 interval that ~0.9 inches of precipitation was received. This resulted in a somewhat uneven stand establishment, which could partially explain these results. Additionally, after October 5, the next rainfall event was not until the November 20-29 interval, when about 0.45 inches were received in total of six smaller events. The dry conditions experienced at planting and during the entire fall, coupled with below-average fall temperatures, did not allow for much forage biomass production and increased the plot-to-plot variability in the measurements.

Stay tuned for First Hollow Stem reports

Another important aspect of dual-purpose wheat production is how long each variety can be grazed in the spring. This is measured as the date for first hollow stem. Wheat varieties can differ by as much as 20-30 days in achieving first hollow stem in the spring. The Wheat Production Group at K-State uses this very same trial to measured first hollow stem during late February and early March, so keep tuned the eUpdate as winter progresses toward spring.

 

Romulo Lollato, Extension Wheat and Forages Specialist
lollato@ksu.edu  

Kavan Mark, Research Assistant
kavanmark58@ksu.edu


Tags:  wheat fall forage dual purpose 

Search
Subscribe