Spring herbicide application decisions on winter wheat: The importance of wheat growth stage

Share Tweet Email

The warm temperatures recently have caused wheat to green up and begin spring growth in most areas of the state. Producers should pay close attention to the growth stage of their wheat before making their herbicide applications.

Dicamba can be applied to wheat between the 2-leaf and jointing stages of wheat. Application of dicamba after wheat reaches the jointing stage of growth causes severe prostrate growth of wheat and significant risk of yield loss. Dicamba is effective for control of kochia, Russian thistle, and wild buckwheat, but is not good for control of mustard species. Kochia, Russian thistle, and wild buckwheat are summer annual weeds that may emerge before or after wheat starts to joint, so timing of dicamba for control of these weeds can sometimes be difficult. Fortunately, dicamba provides some residual control of these weeds following application.  

Other herbicides that must be applied prior to jointing include Agility SG, Beyond (on Clearfield varieties only), Olympus, Olympus Flex, Orion, PowerFlex, Pulsar, Rage D-Tech, and Rave.

MCPA and 2,4-D have different application guidelines. In general, MCPA is safer on wheat than 2,4-D, especially when applied prior to tillering. We recommend that 2,4-D not be applied to wheat until it is well-tillered in the spring. Application of 2,4-D prior to tillering hinders the tillering process, causes general stunting and can result in significant yield loss.

Figure 1. Stunting from an application of 2,4-D to wheat prior to tillering. Photo by Dallas Peterson, K-State Research and Extension.

 

2,4-D is labeled for application to wheat from the full-tiller stage until prior to the boot stage of growth, but is probably safest between full-tiller and jointing stages of growth. Wheat will sometimes exhibit prostrate growth from 2,4-D applications applied in the jointing stage of growth, but yields generally are not significantly affected if applied before the boot stage of growth.

MCPA is relatively safe on young wheat and can be applied after the wheat is in the three-leaf stage (may vary by product label) until it reaches the boot stage of growth. Consequently, MCPA would be preferred over 2,4-D if spraying before wheat is well-tillered. Neither herbicide should be applied once the wheat is near or reaches the boot stage of growth, as application at that time can result in malformed heads, sterility, and significant yield loss (Figure 2). 

Figure 2. Malformed heads from an application of 2,4-D at boot stage. Photo by Dallas Peterson, K-State Research and Extension.

 

Both 2,4-D and MCPA are available in ester or amine formulations. Ester formulations generally provide a little better weed control than amine formulations at the same application rates, but also are more susceptible to vapor drift. Ester formulations generally are compatible for use with fertilizer carriers, while amine formulations often have physical compatibility problems when mixed with liquid fertilizer.

Other herbicides used in the spring on wheat can be applied up to the time the flag leaf is visible, or later. Affinity BroadSpec, Affinity TankMix, Ally Extra SG, Express, Harmony + 2,4-D or MCPA, Harmony Extra, and Supremacy must be applied before the flag leaf is visible. Huskie, Weld, and WideMatch can be applied through the flag leaf stage. Herbicides that can be applied later in the spring – prior to the boot stage -- include Ally + 2,4-D, Amber, Finesse, Starane Ultra, and Starane Plus Salvo.

 

Dallas Peterson, Weed Management Specialist
dpeterso@ksu.edu


Tags: 

Tags
Search
Events
Subscribe