Soybeans can remove significant amounts of nutrients per bushel of grain harvested compared to other row crops (Table 1). Because of this, soybeans can respond to starter fertilizer applications on low-testing soils, particularly phosphorus.
Table 1. Phosphorus and potassium crop removal values. Source: MF2586 Soil Test Interpretations and Fertilizer Recommendations in Kansas, K-State Research and
Extension.
|
|
|
Moisture for |
|
|
|
Corn |
Bushel |
15.5% |
0.33 |
0.26 |
|
Grain sorghum |
Bushel |
15.5% |
0.40 |
0.26 |
|
Wheat |
Bushel |
13.5% |
0.50 |
0.30 |
|
Soybeans |
Bushel |
13% |
0.80 |
1.40 |
Typically, corn shows a greater response to starter fertilizer than soybeans. Part of the reason for that is that soils are generally warmer when soybeans are planted than when corn is planted. The typical response in early growth observed in corn is usually not observed in soybeans. However, yield response to direct soybean fertilization with phosphorus and other nutrients can be expected in low-testing soils.
K-State guidelines for soybeans include taking a soil test for phosphorus (P), potassium (K), sulfur (S), zinc (Zn), and boron (B). If soil test results recommend fertilizer, it should either be applied directly to the soybeans or indirectly by increasing fertilizer rates to another crop in the rotation by the amount needed for the soybeans.
The most consistent response to starter fertilizer with soybeans would be on soils that are very deficient in one of the nutrients listed above or in very high-yield-potential situations where soils have low or medium fertility levels. Furthermore, starter fertilizer in soybeans can be a good way to complement nutrients that may have been removed by high-yielding crops in the rotation, such as corn, and help maintain optimum soil test levels.
Banding fertilizer to the side and below the seed at planting is an efficient application method for soybeans. This method is especially useful in reduced-till or no-till soybeans because P and K have only limited mobility into the soil from surface broadcast applications.
However, with narrow-row soybeans, it may not be possible to install fertilizer units for deep banding. In that situation, producers can surface-apply the fertilizer. Fertilizer should not be placed in-furrow in direct seed contact with soybeans because the seed is very sensitive to salt injury.
Soybean seldom responds to nitrogen (N) in the starter fertilizer. However, some research under irrigated, high-yield environments with sandy soils suggests a potential benefit of small amounts of N in starter fertilizer.
Figure 1. Visual differences with starter P fertilizer on low-testing soils. Photo by Nathan Mueller, former K-State Agronomy graduate student and current Associate Extension Educator at the University of Nebraska West Central Research & Extension Center.
Dorivar Ruiz Diaz, Nutrient Management Specialist
ruizdiaz@ksu.edu
Tags: soybeans starter fertilizer phosphorus in-furrow potassium